Waterguard Puddle – Internal Water Leak & Drip Detection

Waterguard Puddle – Internal Water Leak & Drip Detection Technical specifications as well as all data sheets for the installation, operation and programming of the Waterguard Puddle range are available here.

Installation FAQs

Q. The Puddle is flashing red and not alarming? A. Ensure the Puddle is reset properly after a test or alarm. Press the puddle once to stop the alarm beeping and then again to stop the flashing alarm. The system will then recalibrate for up to 4 minutes which is indicated by a green light. Q. The valve is not closing when water detected?  A. Ensure the Puddle is wired to switch, not positive and negative. If you require any further information please call our office on 01226 244200 and speak to our technical department.
Waterguard Puddle - Technical Specification V19
Waterguard Puddle - Automatic Shut Off User Guide V19
Waterguard Puddle - Alarm Only User Guide V19
Waterguard Valve Relay Puddle - Mains Power V19
Waterguard Puddle - Automatic Shut Off Installation Guide V19-2
Waterguard Puddle - Alarm Only Installation Guide V19
PRINTER SETTINGS: LANDSCAPE - DUPLEX - SHORT EDGE (LEFT).